0,00
(toimituskulut: 0,00)
littleBits light sensor, Valoanturi, littleBits, Monivärinen, 95,2 mm, 190,5 mm, 12,7 mm
Tuotenumero: [4978051] | Valmistaja: Littlebits | Mallinum: 650-0111 | EAN: 859477003706
Tuotetta ei ole varastossa. Lisätietoja
Kuljetus 10,04 - Budbee - Laatikko - Valitse itse mikä laatikko.
Toimituskulut on laskettu vastaanottajan postinumeron perusteella: - Vaihda postinumero
Syötä postinumero toimitusta varten:
Katso kuljetusvaihtoehdot
| Budbee Laatikko - Nouda valitsemastasi laatikosta! | 10,04 |
| Bring - Toimitus huoltopisteeseen | 10,04 |
| Bring - Kotiinkuljetus -arkisin. | 20,08 |
Loppuunmyyty
Tuotetta ei ole varastossa.
EUR
18,69
ilman ALV 14,89
Kokonaishinta sis. toimitus
28,73
Ilmoita minulle, kun tuotetta on jälleen tarjolla varastossa
Tämä toiminto vaatii sisäänkirjautumisen. Luo käyttäjä ja voit käyttää listojamme esim. säännöllisiä ostoksia ja toivelistoja varten
Luo käyttäjä
Kirjaudu
Luo käyttäjä
Kirjaudu
Send på mail
The light sensor Bit can turn your circuit on and off by detecting the brightness or darkness of the environment they are in. control your circuit's with light! The amount of light shining on the sensor will change how your circuit behaves. It's a great way to activate your circuit, and is perfect for alarms!
The light sensor is similar to a dimmer. It measures how much light is shining on it and activates the Bits that follow it based on the amount of light. It has two modes: "light" and "dark". As of the environment gets brighter, the Bits that follow the sensor will gradually turn on. The light sensor also has a "dark mode" that allows it to work in reverse. As it gradually gets darker the Bits that follow will gradually turn on.
Use the small slider on the board to adjust how much light it takes to change the signal. Sliding right increases sensitivity, left decreases it. Older versions of this Bit have a small screw dial instead of the slider. Use the included purple screwdriver to turn this dial.
The light sensor is similar to a dimmer. It measures how much light is shining on it and activates the Bits that follow it based on the amount of light. It has two modes: "light" and "dark". As of the environment gets brighter, the Bits that follow the sensor will gradually turn on. The light sensor also has a "dark mode" that allows it to work in reverse. As it gradually gets darker the Bits that follow will gradually turn on.
Use the small slider on the board to adjust how much light it takes to change the signal. Sliding right increases sensitivity, left decreases it. Older versions of this Bit have a small screw dial instead of the slider. Use the included purple screwdriver to turn this dial.